vastfirm.blogg.se - Arduino relay 1 channel

#ARDUINO RELAY 1 CHANNEL MANUAL#

Due to the different display and different light, the picture may not reflect the actual color of the item.

#ARDUINO RELAY 1 CHANNEL MANUAL#

Please allow -mm differs due to manual measurement. In a word, it is a way of short circuit trigger between signal input and GND negative pole. Low level flip-flops shows that there are voltage for OV trigger mode between the signal input terminal and the ground. High level flip-flops shows that there are trigger mode of the voltage between the signal input terminal and the ground That is to say it is a way of short circuit trigger between signal input and VCC positive pole.

The relay is accessible using screw terminals and can handle up to 2A of current.

The control pin has a pull-down circuit to prevent malfunction relay vacant The 1 Channel 5V Relay Module provides a single relay that can be controlled by any 5V digital output from your microcontroller.

A control indicator, pull off, disconnect does not shine.

Can be used as microcontroller development board module can be used as home appliance control This 1-channel 5V control Single-Pole Double-Throw (SPDT) High-level trigger AC power relay board can be controlled directly via a microcontroller and.

Input directly connected to the microcontroller IO port or digital circuit, the input high.

Easy to use, each set of output 3 line structure simple, reserved 6 output terminal.

Blue terminal connected to the control line is more convenient.

There is a normally open and a normally closed contact.

Control the DC or AC signals, can control the 220V AC load.

Can be used as a microcontroller development board module, can be used as a home appliance control.

Signal input signal, the public side and often start will lead.

With power supply and relay indicator, pull off bright, bright.

this module is in line with international safety standards, the control area and the load area have isolation tank.

COM: Control circuit ground ,Connect to GND.

Switching capacity available by 10A in spite of small size design for high density P.C.

This is a Single Pole Double Throw (SPDT) Configuration relay. It also comes with a LED to indicate the status of relay. The relays terminal (COM, NO and NC) is being brought out with screw terminal. It is designed to interface with micro-controller such as Arduino, PIC and etc. The Single Channel Relay Module is a convenient board which can be used to control high voltage, high current load such as motor, solenoid valves, lamps and AC load. Connectors, Cables, Header, Jack & Socketĭescription: Relay Module DC 5V Single Channel Trigger Relay Control Module With Screw Terminalġ Channel 5V Relay Module 5V Relay 1 Channel Module 5V Relay Board 1CH Single Channel Trigger Relay Control Module With Screw Terminal Relay Switch DC 5V Relay Circuit.Cameras, Oscilloscope, Microscope & Magnifier.